Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

Fabric OS Command Reference 369
53-1001186-01
ipAddrShow
2
ipAddrShow
Displays IP address information for a switch or control processor (CP).
Synopsis ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot_numb [-eth0 | -eth1 | -gate]
Description Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the
command without arguments to display the IP address on a standalone switch, or the IP addresses
for both CPs on a chassis.
On a standalone switch, the command displays the following information:
• Ethernet IP Address
• Ethernet Subnet mask
• The Gateway IP Address
• Dynamic Host Control Protocol (DHCP): on or Off
• Pv6 Auto-configuration Enabled: Yes or No
• Local IPv6 Addresses
On modular platforms, the command displays the following information:
For the chassis:
• Ethernet IP Address
• Ethernet Subnet mask
For each CP:
• Ethernet IP Address
• Ethernet Subnet mask
• Host Name
• Gateway IP Address
If the IPFC network interface is configured for logical switches:
• IPFC address for Virtual Fabric ID
For each CP:
- Backplane IP address
- IPv6 Auto configuration Enabled: Yes or No
If enabled, the command displays:
• All local IPv6 Addresses
• Gateway IP addresses for both CPs
Local IPv6 addresses display the following identifiers:
IP Address type:
• static - A statically configured IPv6 address.