Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

120 Fabric OS Command Reference
53-1001186-01
cryptoCfg
2
dest_filename Specifies the name to be assigned to the imported file. This is a
user-generated file name.
source_filename
Specifies the name of the certificate on the USB storage device from
which you are importing.
--reg -membernode
Registers a member node with the group leader. This command is valid only
on the group leader. The encryption group must have been created prior to
performing member node registration. All member nodes and group leaders
must be registered before encryption group discovery and formation can
occur.
The order in which member node registration is performed defines group
leader succession. At any given time, there is only one active group leader in
an encryption group. The group leader succession list Specifies the order in
which group leadership is assumed if the current group leader is not
available.
The following operands are required when registering a member node with
the group leader:
member_node_WWN
Specifies the switch world wide name of the member node.
member_node_certfile
Specifies the member node CP certificate. You must have exported this file
earlier to external storage and then imported it to the group leader before you
can register a member node. Use cryptocfg --show -file -all to view all
imported certificates.
member_node_IP_addr
Specifies the IP address of the member node to be registered with the group
leader.
--dereg -membernode
Removes the registration for the specified member node. This command is
valid only on the group leader. The node is identified by the switch WWN.
member_node_WWN
Specifies the member node by its switch WWN. This operand is required
when removing a node registration.
--dhchallenge Establishes a link key agreement protocol between a node and an instance of
the primary or backup NetApp Lifetime Key Management (LKM) appliance.
This command generates the Diffie-Hellman challenge that is passed from
the node to the specified NetApp LKM appliance. This command is valid on
all nodes.
vault_IP_addr Specifies the IP address of the NetApp LKM appliance. This operand is
required.