HP LTO Ultrium 6 tape drives UNIX, Linux and OpenVMS configuration guide

If the lunpath hardware path for a giventape drive is “0/4/1/0.0x50060b0000b7f3c8.0x0”.
• The FC bus ID is “0/4/1/0” (including all the numbers separated by “/”).
From the remaining “0x50060b0000b7f3c8.0x0” portion:
• Tape drive WWN (hexadecimal) = 0x50060b0000b7f3c8
• Tape drive SCSI LUN = 0x0 (hexadecimal SCSI-3 64-bit LUN identifier)
Adding stape/estape and eschgr/schgr (media changer driver) to the
kernel
For HP-UX 11i v2 (11.23)
If your tape drive or media changer does not appear in ioscan listing or is listed with H/W Type
“UNKNOWN” you may need to install the appropriate drivers.
Use the ‘sam’ utility. Sam runs as a mouse-driven GUI (Figure 1) on a system with full graphics
capability, or as a console text-based interface (Figure 2). If you use the text-based interface, use
the Tab and arrow keys to navigate, and the Return key to select.
Figure 1 SAM GUI
Figure 2 SAM text-based interface
Adding stape/estape and eschgr/schgr (media changer driver) to the kernel 7