HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

◦ “Rebooting the autoloader (Operations> Reboot Autoloader)” (page 82)
◦ “Enabling password locks (Operations > Enable Autoldr Password Locks)” (page 82)
• “Support” (page 82)
“Powering a drive on or off (Support > Power On/Off Drive)” (page 82)◦
◦ “Running the demonstration (Support > Run Demo)” (page 83)
◦ “Running the slot to slot test (Support > Run Slot To Slot Test)” (page 83)
◦ “Running the wellness test (Support > Run Wellness Test)” (page 83)
◦ “Upgrading firmware (Support > Autoloader FW Upgrade, Support > Drive FW Upgrade)”
(page 84)
◦ “Forcing the drive to eject a tape (Support > Force Drive To Eject Tape)” (page 86)
◦ “Viewing logs (Support > Autoloader Error Log)” (page 85)
◦ “Downloading a support ticket (Support > Download Support Ticket)” (page 86)
LED indicators
The operator panel includes four LEDs that provide a summary of the device status as detailed in
Figure 60 (page 66).
Figure 60 LEDs
Ready. Illuminated when power is on. Blinking during tape drive or robotics activity.Green1.
Clean. Illuminated when a cleaning cartridge should be used.Amber2.
Attention. Illuminated if the device has detected a condition that requires attention.Amber3.
Error. Illuminated if an unrecoverable error occurs. A corresponding error message displays
on the LCD screen.
Amber4.
Autoloader home screen
The first line of the Home screen displays the device's product name as shown in Figure 61 (page
67). The second line displays a brief status message.
66 Operating the tape autoloader