6.3 HP StoreAll Storage Command Line Reference Guide (TA768-96091, June 2013)

DescriptionOption

Lists file-system details.-l

Migrates a file system or file-system segments to a new host.-m

Specifies file-system parameters; written as option=value pairs. Pairs valid in the current

version of StoreAll software are:

-o OPTION=VALUE

compat=yes|no. Declares whether this file system is 32-bit compatible.

maxsegs=n. Defines the number of segments per file system in 32-bit file systems. n can be

set to 15, 31, 63, 127, or 255.

Data retention options are also set with -o.

Specifies audit settings to be enabled or disabled.-oaOPTION1=VALUE1

[,OPTION2=VALUE2,...]

A list of one or more physical volume names, expressed as a comma-separated list (for

example, d1,d2,d3) or a range (for example, d[1-3]).

-p PVLIST

Enables quotas on a file system.-q

A list of one or more logical volume (segment) names, expressed as a comma-separated list

(for example, ilv1,ilv2,ilv3) or a range list (for example, ilv[1-3]).

-s LVLIST

Specifies the tier to which segments are assigned when creating or expanding a file system.-t TIERNAME

Disables 32-bit mode.-w

When used with -i, omits segment details from the output report.-x

Displays the archiving/auditing synchronizer scheduled time for one or all file systems. The

archiving/auditing synchronizer functionality can also be set by modifying the time value for

-Y [-f FSNAME]

Retention Expiration and Autocommit on the Data Retention tab for the Modify Filesystem

Properties window.

Lets you modify the daily time for the archiving/auditing synchronizer to run for a file system.

In this instance, the name of the file system is FSNAME. Use the form hh:mm (a valid hour

-y TIME -f FSNAME

between 0 and 23 inclusive, and a 2-digit minute between 00 and 59 inclusive) to specify

the TIME. The following example sets the starting time for the archiving/auditing synchronizer

to 2 am:

ibrix_fs -y 02:00 -f ibrixfs1

The archiving/auditing synchronizer functionality can also be set by modifying the time value

for Retention Expiration and Autocommit on the Data Retention tab for the Modify Filesystem

Properties window.

Shows the usage for this command.-?