6.3 HP IBRIX X9720/StoreAll 9730 Storage Administrator Guide (AW549-96073, June 2013)

2. From the management console, turn automated failover back on:
<ibrixhome>/bin/ibrix_server -m
3. Confirm that automated failover is enabled:
<ibrixhome>/bin/ibrix_server -l
In the output, HA displays on.
4. From the management console, perform a manual backup of the upgraded configuration:
<ibrixhome>/bin/ibrix_fm -B
5. Verify that all version indicators match for file serving nodes. Run the following command from
the management console:
<ibrixhome>/bin/ibrix_version -l
If there is a version mismatch, run the /ibrix/ibrixupgrade -f script again on the
affected node, and then recheck the versions. The installation is successful when all version
indicators match. If you followed all instructions and the version indicators do not match,
contact HP Support.
6. Verify the health of the cluster:
<ibrixhome>/bin/ibrix_health -l
The output should show Passed / on.
Agile upgrade for clusters with an agile management console configuration
Use these procedures if your cluster has an agile management console configuration. The StoreAll
software 5.4.x to 5.5 upgrade can be performed either online or offline. Future releases may
require offline upgrades.
NOTE: Be sure to read all instructions before starting the upgrade procedure.
Agile online upgrade
Perform the agile online upgrade in the following order:
• File serving node hosting the active management console
• File serving node hosting the passive management console
• Remaining file serving nodes and StoreAll clients
Upgrading the file serving nodes hosting the management console
Complete the following steps:
1. On the node hosting the active management console, force a backup of the management
console configuration:
<ibrixhome>/bin/ibrix_fm -B
The output is stored at /usr/local/ibrix/tmp/fmbackup.zip. Be sure to save this file
in a location outside of the cluster.
2. On the active management console node, disable automated failover on all file serving nodes:
<ibrixhome>/bin/ibrix_server -m -U
3. Verify that automated failover is off:
<ibrixhome>/bin/ibrix_server -l
In the output, the HA column should display off.
4. On the node hosting the active management console, place the management console into
maintenance mode. This step fails over the active management console role to the node
currently hosting the passive agile management console.
<ibrixhome>/bin/ibrix_fm -m maintenance -A
194 Cascading Upgrades