6.3 HP IBRIX X9720/StoreAll 9730 Storage Administrator Guide (AW549-96073, June 2013)

Completing the upgrade
1. From the management console, turn automated failover back on:
<ibrixhome>/bin/ibrix_server -m
2. Confirm that automated failover is enabled:
<ibrixhome>/bin/ibrix_server -l
In the output, HA displays on.
3. Verify that all version indicators match for file serving nodes. Run the following command from
the management console:
<ibrixhome>/bin/ibrix_version -l
If there is a version mismatch, run the /ibrix/ibrixupgrade -f script again on the
affected node, and then recheck the versions. The installation is successful when all version
indicators match. If you followed all instructions and the version indicators do not match,
contact HP Support.
4. Propagate a new segment map for the cluster:
<ibrixhome>/bin/ibrix_dbck -I -f FSNAME
5. Verify the health of the cluster:
<ibrixhome>/bin/ibrix_health -l
The output should specify Passed / on.
Standard offline upgrade
This upgrade procedure is appropriate for major upgrades. The management console must be
upgraded first. You can then upgrade file serving nodes in any order.
Preparing for the upgrade
1. From the management console, disable automated failover on all file serving nodes:
<ibrixhome>/bin/ibrix_server -m -U
2. From the management console, verify that automated failover is off. In the output, the HA
column should display off.
<ibrixhome>/bin/ibrix_server -l
3. Stop the NFS and SMB services on all file serving nodes to prevent NFS and SMB clients from
timing out:
<ibrixhome>/bin/ibrix_server -s -t cifs -c stop
<ibrixhome>/bin/ibrix_server -s -t nfs -c stop
Verify that all likewise services are down on all file serving nodes:
ps -ef | grep likewise
Use kill -9 to kill any likewise services that are still running.
4. From the management console, unmount all StoreAll file systems:
<ibrixhome>/bin/ibrix_umount -f <fsname>
Upgrading the management console
Complete the following steps on the management console:
1. Force a backup of the configuration:
<ibrixhome>/bin/ibrix_fm -B
The output is stored at /usr/local/ibrix/tmp/fmbackup.zip. Be sure to save this file
in a location outside of the cluster.
192 Cascading Upgrades