6.0 HP X9320 Network Storage System Administrator Guide (AW542-96009, December 2011)

/etc/init.d/network restart

service network restart

Verify that you can ping the new local IP address.

4. Configure the agile management console:

ibrix_fm -c <cluster_VIF_addr> -d <cluster_VIF_device> –n <cluster_VIF_netmask> -v cluster -I

<local_cluster_IP_addr>

In the command, <cluster_VIF_addr> is the old cluster IP address for the original

management console and <local_cluster_IP_addr> is the new IP address you acquired.

For example:

[root@x109s1 ~]# ibrix_fm -c 172.16.3.1 -d bond0:1 -n 255.255.248.0 -v cluster

-I 172.16.3.100

Command succeeded!

The original cluster IP address is now configured to the newly created cluster VIF device

(bond0:1).

5. If you created the interface bond1:0 in step 3, now set up the user network VIF, specifying

the user VIF IP address and VIF device used in step 3.

NOTE: This step does not apply to CIFS/NFS clients. If you are not using X9000 clients,

you can skip this step.

Set up the user network VIF:

ibrix_fm -c <user_VIF_IP> -d <user_VIF_device> -n <user_VIF_netmask> -v user

For example:

[root@x109s1 ~]# ibrix_fm -c 10.30.83.1 -d bond1:0 -n 255.255.0.0 -v user

Command succeeded

6. Register the agile management console (also known as agile FM) to the cluster:

ibrix_fm –R <FM hostname> -I <local_cluster_ipaddr>

7. From the agile management console, verify that the definition was set up correctly:

grep –i vif /etc/ibrix/fusion.xml

The output should be similar to the following:

NOTE: If the output is empty, restart the fusionmanager services as in step 8 and then recheck.

8. Restart the fusionmanager services:

/etc/init.d/ibrix_fusionmanager restart

NOTE: It takes approximately 90 seconds for the agile management console to return to

optimal with the agile_cluster_vif device appearing in ifconfig output. Verify that

this device is present in the output.

9. Install the file serving node software on the agile management console node:

ibrix/ibrixinit -ts -C <cluster_interface> -i <agile_cluster_VIF_IP_Addr>

For example:

ibrix/ibrixinit -ts -C eth4 -i 172.16.3.100

10. Verify that the agile management console is active:

ibrix_fm –i

For example:

[root@x109s1 ~]# ibrix_fm -i

FusionServer: x109s1 (active, quorum is running)

78 Migrating to an agile management console