HP StoreAll OS 6.5.1 Release Notes
3 [Absent]
4 [Absent]
5 SAS HP On OK Off 10.20.10.115
6 SAS HP On OK Off 10.20.10.116
7 SAS HP On OK Off 10.20.10.117
8 SAS HP On OK Off 10.20.10.118
Totals: 6 interconnect modules installed, 6 powered on.
◦ Output on the X9720:
The command displays the following:
Bay Interconnect Type Manufacturer Power Health UID Management IP
--- ----------------- -------------------- ------- --------- ---
---------------
1 Ethernet HP On OK Off 10.20.4.3
2 Ethernet HP On OK Off 10.20.4.4
3 SAS HP On OK Off 10.20.4.5
4 SAS HP On OK Off 10.20.4.6
5 [Absent]
6 [Absent]
7 [Absent]
8 [Absent]
Totals: 4 interconnect modules installed, 4 powered on.
5. Connect to the down SAS interconnect by entering the following command:
connect interconnect <victim SAS interconnect bay number>
For example switch 3 shown in the following output is the victim SAS interconnect:
connect interconnect 3
NOTE: This pass through connection to the integrated I/O console is provided for
convenience and does not supply additional access control. For security reasons, use the
password features of the integrated switch.
The following is an example of command’s output:
Connecting to integrated switch 3 at 115200,N81...
Escape character is '<Ctrl>_' (Control + Shift + Underscore)
Press [Enter] to display the switch console:
-----------------------------------------------------------------------------
WARNING: This is a private system. Do not attempt to login unless you are an
authorized user. Any authorized or unauthorized access and use may be moni-
tored and can result in criminal or civil prosecution under applicable law.
-----------------------------------------------------------------------------
VSM-0025B3D4AD5D login: exds
Password:
HP Virtual SAS Manager CLI 2.2-17.0 (SEP 1 FW 2.82) (SEP 2 FW 2.82
6. Once the prompt is given, reset the SAS switch by entering the following command.
sw local reset hardware forced
The following is an example of the command’s output from a 9730:
[2013-Jan-29 11:06:39] Hardware reset on Switch 5, Scope: Local switch only.
Performing hard reset
7. Retry the operation (discovery/flash recommendation/flash) that previously failed.
8. After the switch reboots and displays the login prompt, press the following keys in order:
1. Press the RETURN key.
2. Press the tilde (~) key.
3. Press the period (.) key.
• Firmware update alert events are cleared every 24 hours. Ignore the alert for the next 24 hours
if you updated the firmware in response to an alert.
24 Workarounds