HP StorageWorks 12000 Gateway Virtual Library System User Guide (AH814-96018, December 2012)

12 CLI Command Set
This section describes the VLS command-line interface (CLI) command set. The CLI command allows
you to remotely configure, manage, and monitor the VLS over the LAN using a secure shell session.
It also allows you to locally configure, manage, and monitor the VLS through the serial connection.
Commands
There are two types of CLI commands:
• CLI-only commands
Commands that are processed by the CLI and affect only the CLI.
• VLS commands
Commands that are passed to the VLS to configure, manage, and monitor the VLS.
Conventions
All command arguments are case-sensitive and optional. They can be specified in any order. There
are several option tags associated with a command. The following conventions are used in this
section to identify option tags and arguments:
• An option tag is preceded by a -.
• The argument is separated from the option tag by a space.
• If an argument contains a space, it must be enclosed by either two single quotes or two double
quotes.
• If there is no argument after an option tag, the option is a switch.
• An * after an argument means the argument (including its option tag) can be repeated.
• A | between a compound argument means one or the other argument.
CLI-only Commands
This section describes the CLI-only commands in the VLS CLI command set.
Connection Commands
Use the CLI commands in CLI connection commands to establish or close a VLS secure shell or
serial user interface session.
Table 14 CLI Connection Commands
DescriptionCommand
Terminates the CLI session.bye | done | exit |
logout | quit
Closes the connection to the VLS.close
Displays the fully qualified name of the VLS and its IP address.getHost
Connects to a host. Where <-tag> can be:
-a<s> - Host name (localhost is default) (optional)
connect
-p<s> - Password (optional)
-u<s> - userid (optional)
132 CLI Command Set