HP StorageWorks 1000i Virtual Library System User Guide (406685-002, October 2006)

Table 5 Diagnostics messages
Error message
Meaning and/or corrective action
Error: There is a drive in the system
that is smaller than the smallest
supported size, which is 232
GB.
Drive sizes in GB are listed below
and correspond to drives from left to
right as you face the front of the
unit
(power switch on the right).
### ### ### ###
NOTE:
A
size of zero (0) indicates a bad drive.
A drive in the system is below the minimum size. If
possible, change the drive size. If the drive is physically
too small, upgrade the drive to an acceptable size.
The drive(s) indicated above failed the
diagnostic test and must be
replaced.
Note which drive(s) failed, press
the
power button to shut down the
system,
and replace the drive(s).
One or more d rives have failed the diagnostic test.
Replace these drives.
The diagnostic test detected no working
drives. The drives may need to be
replaced; however, it is likely
that
the failure is in the array,
power
supply, or some other device. Do
not replace the drives at this time.
Instead, contact HP technical
support
for further assistance.
All drives have failed diagnostic testing. Contact HP
technical support. DO NOT replace the drives at this
time.
Warning: The drives in the system
are not the same size. Drive sizes in
GB are listed below and correspond to
drives from left to right as you
face
the front of the unit with the
power
switch on the right.
### ### ### ###
All drives will have the usable
capacity of the smallest drive.
Do you wish to continue? (Y/N)
The drives are not the same size. Select Y to allow the
smallest drivetoset thesizeofall drives on thesystem.
Select N to exit the diagnostic program and change the
limiting
drive or its configured size.
Error: One or both RAIDs are
corrupted. Do you want to rebuild
the RAIDs and reinstall the firmware?
(Y/N) Note: This will destroy all
data
in the RAIDs.
HP recommendsyou select Yunlessyou need to recover
data and think that the data RAID might still be good.
In
this case, call HP technical support.
The boot RAID is the wrong size. The
optimal size is 4 GB. Do you want to
rebuild the RAIDs and reinstall the
firmware? (Y/N) Note: This will
destroy all data in the RAIDs.
The boot raid h as been manually changed to a size
other
than 4 GB. The RAID will cease functioning when
it
runs out of room.
The data RAID is the wrong size. The optimal size is
1396 GB; the current size is ###. Do you want to
rebuild the RAIDs a nd reinstall the firmware? (Y/N)
Note: Thiswilldestroy alldata in the RAIDs.
The data raid is the wrong size (2 TB unit) because it has
been
manually changed to a size other than the optimal
size. The can severely limit functionality depending on
how much smaller than optimal the data RAID is.
The RAIDs are in good shape, do you
want to reinstall the firmware?
The RAIDs and drives passed the diagnostic testing. You
have the option of reinstalling firmware now. Reasons
to reinstall firmware include: a firmware update failed,
a
firmware update succeeded but the appliance is not
working properly, the firmware is corrupted, or you
have been instructed by HP technical support to reinstall
firmware.
The boot RAID is rebuilding at [print
string specified here]. Please wait.
The boot RAID is rebuilding. Wait for the process to
end.
80
Maintenance