HP StorageWorks 1000i Virtual Library System User Guide (406685-002, October 2006)

Figure 40 Targets found
4. The fi nal step is to m a ke the devices known to the host’s operating system. This is done by clicking
on a
devic
e
in the iSCSI Initiator Properties window (Figure 40), then clicking on Log On.
5. The Log On
to
Target window displays (Figure 41). If you want a persistent device (one that survives
host reboots), click Automatically restore this connection when the system boots.Click OK.
Figure 41 Log on to targ e t
NOTE:
Enabling multi-path is not recommended unless there is a specificreasonto enableit. For
most configurations, it is neither necessary nor desirable.
6. The device will now be seen by the op erating system which will attempt to load the necessary
device drivers. (If drivers are n ot necessary, they need not be loaded.) If the drivers do not already
exist on the host, you can download the HP LTO Ultrium-2 tape drivers from the HP web site
(h
ttp://www.hp.com). Complete the logon procedure for each device listed.
The backup devices are now available for use with a backup progra m.
HP StorageWorks 1000i Virtual Library System
51