HP StorageWorks Fabric OS 5.X MIB Reference Guide (AA-RVHXB-TE, September 2005)

Fabric OS 5.x MIB reference guide 149
swAdmStatus
OID 1.3.6.1.4.1.1588.2.1.1.1.1.8
Description The desired administrative status of the switch. A management station might place the
switch in a desired state by setting this object accordingly. Possible values are:
• online (1): Set the switch to be accessible by an external FC port.
• offline (2): Set the switch to be inaccessible.
• testing (3): Set the switch to run the built-in test.
• faulty (4): Set the switch to a soft faulty condition.
• reboot (5): Set the chassis to reboot in 1 second.
• fastboot (6): Set the chassis to fastboot in 1 second. Fastboot causes the
chassis to boot but omit the power-on self test (POST).
• switchReboot (7): Set the current switch to reboot in 1 second.
Note When the switch is in faulty state, only two states can be set: faulty and
reboot/fastboot/switchReboot.
For the SAN Switch 2/32, the testing (3), faulty (4), and switchReboot (7) values are not
applicable.
For the SAN Switch 4/32, the testing (3), faulty (4), and switchReboot (7) values are not
applicable.
The switchReboot (7) value applies only to the Core Switch 2/64, SAN Director 2/128,
and 4/256 SAN Director.
swTelnetShellAdmStatus
Note Applicable to HP Fabric OS 2.x and 3.x only.
OID 1.3.6.1.4.1.1588.2.1.1.1.1.9
Description The desired administrative status of the telnet shell. Possible values are:
• Unknown (0): The status of the current telnet shell task is unknown.
• Terminated (1): The current telnet shell task is deleted.
Note 2.x, 3.x: By setting it to 1 (terminated), the current telnet shell task is deleted. When this
variable instance is read, it reports the value last set through SNMP.
4.x: Not Supported.
5.x: Not Supported.
swSsn
OID 1.3.6.1.4.1.1588.2.1.1.1.1.10
Description The soft serial number of the switch.
Note By default, the return value is the WWN of the switch.
Flash administration
The next six objects are related to firmware or configuration file management. The underlying method in
the transfer of the firmware or configuration file is based on either FTP or remote shell. If a password is
provided, then FTP is used. If no password is provided, then remote shell is used.
Use one of the two following methods to manage the firmware or switch configuration file in the switch
flash.