HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 347
Recommended Action
Verify that the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity
INFO
SEC-1139
Message
Probable Cause
Indicates that the receiving switch fails to validate the security database sending from the primary FCS
switch. This message usually indicates that the data package is corrupted, the time stamp on the package
is out of range as a result of a replay attack or out-of-sync time service, or the signature verification failed.
Signature verification failure indicates either an internal error (such as losing the primary public key) or an
invalid database.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that switch.
This message might also be the result of an internal corruption or a hacker attack to the secure fabric.
Severity
ERROR
SEC-1142
Message
Probable Cause
Indicates that the new polices are rejected due to the reason specified.
Recommended Action
Use proper syntax when entering policy information.
Severity
INFO
SEC-1145
Message
<timestamp>, [SEC-1139], <sequence-number>,, ERROR, <system-name>,
THe RSNMP_POLICY cannot exist without the WSNMP_POLICY.
<timestamp>, [SEC-1142], <sequence-number>,, INFO, <system-name>,
Reject new policies. <reason text>.
<timestamp>, [SEC-1145], <sequence-number>,, INFO, <system-name>, A
security admin event has occurred. This message is for information
purpose only. The message for individual event is: <Event specific
data>