HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

342 Error messages
Severity
ERROR
SEC-1115
Message
Probable Cause
Indicates that during an attempted secFcsFailover, no primary FCS is present in the fabric.
Recommended Action
Run the secFabricShow command to verify that all switches in fabric are in the ready state. When all
switches are in the ready state, retry the operation.
Severity
ERROR
SEC-1116
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1117
Message
Probable Cause
Indicates that the switch failed to save the data received by the primary FCS switch. This data can be an
FCS password, a non-FCS password, SNMP data, or multiple user authentication data.
Recommended Action
Run the secFabricShow command to verify that all switches in fabric are in the ready state. When all
switches are in the ready state, retry the operation.
<timestamp>, [SEC-1115], <sequence-number>,, ERROR, <system-name>,
No primary FCS to failover.
<timestamp>, [SEC-1116], <sequence-number>,, ERROR, <system-name>,
Fail to commit failover.
<timestamp>, [SEC-1117], <sequence-number>,, INFO, <system-name>,
Fail to set <data>.