HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 337
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1097
Message
Probable Cause
Indicates that the specified policy could not be found.
Recommended Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
SEC-1098
Message
Probable Cause
Indicates that the specified policy could not be found.
Recommended Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and
contact your switch service provider.
Severity
ERROR
SEC-1099
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
<timestamp>, [SEC-1097], <sequence-number>,, ERROR, <system-name>,
Cannot find <active or defined> policy set.
<timestamp>, [SEC-1098], <sequence-number>,, ERROR, <system-name>,
No <active or defined> FCS list.
<timestamp>, [SEC-1099], <sequence-number>,, ERROR, <system-name>,
Please enable your switch before running secModeEnable.