HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

320 Error messages
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1038
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1040
Message
Probable Cause
Indicates that the port list contains the wildcard asterisk (*) character.
Recommended Action
You cannot use the asterisk in a port list. Enter the port list values without any wildcards.
Severity
ERROR
SEC-1041
Message
<timestamp>, [SEC-1038], <sequence-number>,, ERROR, <system-name>,
Invalid domain <Domain ID>.
<timestamp>, [SEC-1040], <sequence-number>,, ERROR, <system-name>,
Invalid portlist (<port list>). Cannot combine * with port member in
the same portlist.
<timestamp>, [SEC-1041], <sequence-number>,, ERROR, <system-name>,
Invalid port member <port member> in portlist (<port list>).
<Reason>.