HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

254 Error messages
FW-1436
Message
Probable Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of marginal ports
is greater than or equal to the policy set using the switchStatusPolicySet command. A port is faulty
when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol error, CRC error,
Port state change or Buffer Limited Port is above the high boundary.
Recommended Action
Replace any faulty or deteriorating SFPs.
Severity
WARNING
FW-1437
Message
Probable Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of faulty ports is
greater than or equal to the policy set by the switchStatusPolicySet command. A port is considered
faulty due to hardware failure such as a faulty SFP or port.
Recommended Action
Replace any faulty or deteriorating SFPs.
Severity
WARNING
FW-1438
Message
Probable Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of missing SFPs
is greater than or equal to the policy set by the switchStatusPolicySet command.
Recommended Action
Run the switchStatusPolicySet command to modify the SFP policy or to add SFPs to the empty ports.
<timestamp>, [FW-1436], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Marginal ports: <Num of
marginal ports and the port numbers> marginal ports. (Port(s)
<Unknown>)
<timestamp>, [FW-1437], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Faulty ports: <Num of
faulty ports> faulty ports.
<timestamp>, [FW-1438], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Missing SFPs: <Num of
missing SFPs> missing SFPs.