HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

168 Error messages
Recommended Action
Use a frame analyzer to verify that the reported section ID is 0. Any connected (other manufacturer) switch
with a section ID other than 0 is incompatible in a fabric of switches. Disconnect the offending switch.
Severity
ERROR
FSPF-1006
Message
Probable Cause
Indicates that the FSPF version is not supported on the specified input port.
Recommended Action
Update the FSPF version by running the firmwareDownload command to update the firmware to the
latest version. All current versions of the Fabric OS support FSPF version 2, which is the correct version.
Severity
ERROR
FSS error messages
FSS-1001
Message
Probable Cause
Indicates that an application has dropped a high availability (HA) data update.
Recommended Action
Run the haSyncStart command if this is a dual-CP system, or reboot the switch if it is a nonbladed
system. The haSyncStart command will automatically run the haSyncStop command if required.
If the message persists, run supportFtp and traceFtp -e (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
Severity
WARNING
FSS-1002
Message
<timestamp>, [FSPF-1006], <sequence-number>,, ERROR, <system-name>,
FSPF Version <FSFP version> not supported, input port = <port
number>
<timestamp>, [FSS-1001], <sequence-number>,, WARNING,
<system-name>, Application dropping HA data update.
<timestamp>, [FSS-1002], <sequence-number>,, WARNING,
<system-name>, Application sending too many concurrent HA data
updates