HP StorageWorks Fabric OS 4.4.0F Release Notes (AA-RW89A-TE, October 2005)

Core Switch 2/64 and SAN Director 2/128 installation guide, part number: AA-RVUSC-TE32

Core Switch 2/64 and SAN Director 2/128 installation guide,

part number: AA-RVUSC-TE

This section provides information on last-minute additions or corrections to the

HP StorageWorks Core

Switch 2/64 and SAN Director 2/128 installation guide,

part number AA–RVUSC–TE.

On page 45, insert the following “Powering off the switch” section:

To power off the Core Switch 2/64:

1. Shut down both logical switches:

a. Enter the switchShutdown command to ensure a graceful shutdown of Switch 1, and

verify the command has completed and displayed the message “Cleaning up kernel

modules.....Done”.

b. From the active CP card session, log into Switch 0 by entering the login command, logging

in as admin, then entering “0” to log into Switch 0.

c. Enter the switchShutdown command to ensure a graceful shutdown of Switch 0, and

verify the command has completed and displayed the message “Cleaning up kernel

modules.....Done”.

Example:

SW1:admin> switchshutdown

Stopping all switch daemons...Done.

Powering off slot 7...Done.

Powering off slot 10...Done.

Checking all slots are powered off...Done.

Cleaning up kernel modules.....Done

SW1:admin>

SW1:admin> login

Enter Switch Number to Login <0 or 1>: 0

password: xxxx

SW0:admin>

SW0:admin> switchshutdown

Stopping all switch daemons...Done.

Powering off slot 1...Done.

Powering off slot 4...Done.

Checking all slots are powered off...Done.

Cleaning up kernel modules.....Done

SW0:admin>