Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 62-3
Publication Number: 53-1000242-01
SWCH-1006
62
SWCH-1006
Message
Probable
Cause
Indicates that the standby CP does not support NPIV functionality and the switch has some NPIV
devices logged into the fabric.
Recommended
Action
Load a firmware version on standby that supports NPIV functionality, using the firmwareDownload
command.
Severity WAR NIN G
SWCH-1007
Message
Probable
Cause
Indicates that the switch port is disabled due to the reason displayed in the message.
Recommended
Action
Based on the disable reason displayed, proper corrective action may to be required to restore the port.
If insufficient frame buffers is the disable reason, reduce the distance or speed settings for the port to
reduce the buffer requirement of the link. Alternatively, one or more ports in the port group must be
disabled to make more buffers available for the link.
Please refer to the Fabric OS Administrator’s Guide for more information about buffers.
Severity WAR NIN G
SWCH-1008
Message
Probable
Cause
Indicates that the blade is enabled with the port configuration that already has already area swapped.
<timestamp>, [SWCH-1006], <sequence-number>,, WARNING, <system-
name>, HA state out of sync: Standby CP (ver = <standby SWC
version>) does not support NPIV functionality. (active ver =
<active SWC version>, NPIV devices = <'1' if NPIV devices exist;
Otherwise '0'. >)
<timestamp>, [SWCH-1007], <sequence-number>,, WARNING, <system-
name>, Switch port <port number> disabled due to \"<disable
reason>\".
<timestamp>, [SWCH-1008], <sequence-number>,, WARNING, <system-
name>, <area string> are port swapped on ports that do not support
port swap. Slot <slot number> will be faulted.