Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 62-1
Publication Number: 53-1000242-01
Chapter
62
SWCH System Messages
SWCH-1001
Message
Probable
Cause
Indicates that the switch is enabled before it is ready.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
SWCH-1002
Message
Probable
Cause
Indicates that the device is not present in the authorized profile list.
Recommended
Action
Verify that the device is authorized to log in to the switch. If the device is authorized, run the
secPolicyDump command to verify whether the specified device WWN is listed. If it is not listed, run
the secPolicyAdd command to add this device to an existing policy.
Severity INFO
<timestamp>, [SWCH-1001], <sequence-number>,, ERROR, <system-name>,
Switch is not in ready state - Switch enable failed switch status=
0x<switch status>, c_flags = 0x<switch control flags>
<timestamp>, [SWCH-1002], <sequence-number>,, INFO, <system-name>,
Security violation: Unauthorized device <wwn name of device> tries
to flogin to port <port number>