HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 383
Table 6 lists the upgrade state and the associated code value for that state. This information is transient
within the Boot ROM environment and is provided here only for assisting support personnel in the debug
process.
Recommended Action
Run the firmwareDownload status command for more information.
Refer to the HP StorageWorks Fabric OS 5.x administrator guide for troubleshooting information.
Severity
INFO
SULB-1010
Message
Probable Cause
Indicates that a firmware commit failed to update the secondary partition.
Table 6 Upgrade state and code value
Upgrade State Code
SUS_PEER_CHECK_SANITY 0x21
SUS_PEER_FWDL_BEGIN 0x22
SUS_SBY_FWDL_BEGIN 0x23
SUS_PEER_REBOOT 0x24
SUS_SBY_REBOOT 0x25
SUS_SBY_FABOS_OK 0x26
SUS_PEER_FS_CHECK 0x27
SUS_SELF_FAILOVER 0x28
SUS_SBY_FWDL1_BEGIN 0x29
SUS_SELF_FWDL_BEGIN 0x2a
SUS_SELF_COMMIT 0x2b
SUS_SBY_FWC_BEGIN 0x2c
SUS_SBY_COMMIT 0x2d
SUS_SBY_FS_CHECK 0x2e
SUS_ACT_FWC_BEGIN 0x2f
SUS_PEER_RESTORE_BEGIN 0x30
SUS_SBY_RESTORE_BEGIN 0x31
SUS_PEER_FWC_BEGIN 0x32
SUS_PEER_FS_CHECK1 0x33
SUS_FINISH 0x34
SUS_COMMIT 0x35
<timestamp>, [SULB-1010], <sequence-number>,, INFO, <system-name>,
Firmwarecommit failed (status=0x<firmwarecommit error code>).