HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 329
SEC-1073
Message
Probable Cause
Indicates that the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and
contact your switch service provider.
Severity
ERROR
SEC-1074
Message
Probable Cause
Indicates that a security command was run on a switch that is not allowed to run it either because it is in
non-secure mode or because it does not have required FCS privilege.
Recommended Action
If a security operation that is not allowed in non-secure mode is attempted, do not perform the operation in
non-secure mode. In secure mode, run the command from a switch that has required privilege, that is,
either a backup FCS or primary FCS.
Severity
ERROR
SEC-1075
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
<timestamp>, [SEC-1073], <sequence-number>,, ERROR, <system-name>,
No FCS policy in list!
<timestamp>, [SEC-1074], <sequence-number>,, ERROR, <system-name>,
Cannot execute the command on this switch. Please check the secure
mode and FCS status.
<timestamp>, [SEC-1075], <sequence-number>,, ERROR, <system-name>,
Fail to <operation> new policy set on all switches.