HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

288 Error messages
MS-1006
Message
Probable Cause
Indicates that MS received IU data of unexpected size. The IU payload and the IU size might be
inconsistent with each other or with the command that is currently being processed. This message is often
transitory.
Recommended Action
Wait a few minutes and try the operation again.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
MS-1008
Message
Probable Cause
MS failed while initializing the specified action. This message is often transitory.
The following actions might be displayed:
• <while writing to ms_els_q>
MS is unable to write a message to the MS Extended Link Service Queue.
• <while inserting timer to timer list>
MS is unable to add a timer to a resource.
Recommended Action
Wait a few minutes and try the operation again.
If the error persists, check the available memory on the switch using memShow.
Severity
ERROR
MS-1021
Message
Probable Cause
Indicates that the FSS warm recovery failed during WARM INIT phase of a reboot.
<timestamp>, [MS-1006], <sequence-number>,, ERROR, <system-name>,
MS Unexpected iu_data_sz=<number of bytes>
<timestamp>, [MS-1008], <sequence-number>,, ERROR, <system-name>,
MS Failure while initializing <action>
<timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>,
MS WARMBOOT failure(FSS_MS_WARMINIT failed. Reason=<failure
reason>)