HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

126 Error messages
Probable Cause
Indicates that there was a failure to read chassis type from the system.
Recommended Action
Verify that the CP blade is operational and properly seated in the slot.
Severity
CRITICAL
EM-1019
Message
Probable Cause
Indicates that the current chassis config option is not supported by the firmware on the standby CP. This is
true even if the standby comes up and appears to be operational. HA synchronization of the CPs will not
be allowed.
Recommended Action
Use the chassisConfig command to change the chassis config option to 1, or upgrade the firmware on
the standby CP to match the firmware on the active CP.
Severity
WARNING
EM-1028
Message
Probable Cause
Indicates that problems were encountered when the software attempted to write to the memory of the FRU
specified in the error message. The return code is for internal use only. This is a serious FRU hardware
problem.
The FRU ID value is composed of a FRU type string and an optional number to identify the unit, slot, or
port. The FRU ID value can be:
• Switch for fixed port count switches.
• Slot 1 through Slot 10 for the Core Switch 2/64, SAN Director 2/128, and 4/256 SAN Director.
• PS 1 through PS 4 (power supplies) for the Core Switch 2/64, SAN Director 2/128, and 4/256 SAN
Director, or PS 1 through PS 2 for the SAN Switch 2/32 and SAN Switch 4/32. The power supplies on
the SAN Switch 2/8V and the SAN Switch 2/16V are not field replaceable.
• Fan 1 through Fan 3 for the Core Switch 2/64, SAN Director 2/128, 4/256 SAN Director, and SAN
Switch 4/32 (six fans in three FRUs). Fan 1 through Fan 6 for the SAN Switch 2/32 (six fans in three
FRUs). The fans on the SAN Switch 2/8V and the SAN Switch 2/16V are not field replaceable.
<timestamp>, [EM-1019], <sequence-number>,, WARNING, <system-name>,
Current chassis configuration option <Chassis config option
currently in effect> is not compatible with standby firmware
version (Pre 4.4), cannot allow HA Sync
<timestamp>, [EM-1028], <sequence-number>,, CRITICAL,
<system-name>, HIL Error: <function> failed to access FRU: <FRU Id>
(rc=<return code>).