Fabric OS Administrator's Guide v7.0.0 (53-1002148-02, June 2011)

190 Fabric OS Administrator’s Guide
53-1002148-02
Brocade configuration form
8
6. Verify the LISL ports are set up correctly.
Example of a non-interactive download from a switch with an FID = 8, to FID 10
configdownload -fid 8 -sfid 10 -ftp 10.1.2.3,UserFoo,config.txt,password
Example of configDownload on a switch
5100:FID128:admin> configdownload -vf
Protocol (scp, ftp, sftp, local) [ftp]:
Server Name or IP Address [host]: 10.1.2.3
User Name [user]: UserFoo
Path/Filename [<home dir>/config.txt]: 5100_FID89.txt
*** CAUTION ***
This command is used to download the VF configuration to the
switch. Afterwards, the switch will be automatically rebooted
and the new VF settings will be used. You will then need to
run configdownload again to install the configuration(s) for
any logical switch(s) that are setup in the new VF configuration.
Do you want to continue [y/n]: y
(output truncated)
Restrictions
The following restrictions should be observed when using the configUpload or configDownload
commands when Virtual Fabrics is enabled:
• The -vf option is incompatible with the –fid, –sfid, or –all options. Any attempt to combine it
with any of the other three will fail the configuration upload or download operation.
• You are not allowed to modify the Virtual Fabric configuration file after it has been uploaded.
Only minimal verification is done by the configDownload command to ensure it is compatible,
much like the normal downloaded configuration file.
• After the configDownload -vf command completes and reboots your switch, you must then
download the matching regular configuration using the configDownload -all command. This
ensures proper behavior of the system and logical switches.
• All of the attributes of the Virtual Fabric configuration file will be downloaded to the system and
take effect. This includes, but is not limited to, logical switch definitions, whether the Virtual
Fabrics feature is enabled or disabled, and the F_Port trunking ports, except the LISL ports.
The LISL ports on the system are not affected by the Virtual Fabric configuration file download.
Brocade configuration form
Use the form in Table 45 as a hard copy reference for your configuration information.
In the hardware reference manuals for the Brocade DCX and DCX-4S enterprise-class platform,
there is a guide for FC port setting tables. The tables can be used to record configuration
information for the various blades.