Brocade Fabric OS MIB Reference Supporting Fabric OS v7.0.0 (53-1002151-01, April 2011)

6 Fabric OS MIB Reference
53-1002151-01
Understanding SNMP basics
1
3. swFCPortScn
This trap is generated by a port state change.
4. swEventTrap
This trap is generated by any switch event reported to the system error log.
The desired severity level is introduced to filter a swEvent trap based on the severity level.
5. swFabricWatchTrap
This trap is generated when any Fabric Watch threshold is reached.
The desired severity level is introduced to filter a swFabricWatchTrap based on the severity
level.
6. swTrackChangesTrap
This trap is generated by a login or a logout.
7. swIPv6ChangeTrap
This trap is generated when an IPv6 address status change event occurs. It is generated only
when IPv6 stateless state changes to the deprecation state and not for address change
notification.
8. swPmgrEventTrap
This trap is generated when any partition manager change happens.
9. swFabricReconfigTrap
The trap to be sent for tracking fabric reconfiguration.
10. swFabricSegmentTrap
The trap to be sent for tracking segmentation.
11. swExtTrap
The trap adds the SSN binding to the traps if it is enabled.
12. swStateChangeTrap
This trap is sent when the switch changes its state to online or offline.
13. swPortMoveTrap
This trap is sent when the virtual ports are moved from one switch to another.
14. swBrcdGenericTrap
This trap is sent for one of the events, such as fabric change, device change, FAPWWN change,
and FDMI events. This trap is for Brocade use.
The Brocade trap (SW-TRAP) can be configured to send traps using the snmpConfig command. For
more information on this command, refer to Table 5 or the Fabric OS Command Reference.