HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 207
FW-1194
Message
Probable Cause
Indicates that the number of state changes that the port experiences has risen above the high boundary.
The state of the port has changed for one of the following reasons: the port has gone offline, has come
online, is testing, is faulty, has become an E_Port, has become an F_Port, has segmented, or has become a
trunk port.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
WARNING
FW-1195
Message
Probable Cause
Indicates that the number of state changes that the port experiences has changed from a value outside of
the acceptable range to a value within the acceptable range. The state of the port has changed for one of
the following reasons: the port has gone offline, has come online, is testing, is faulty, has become an
E_Port, has become an F_Port, has segmented, or has become a trunk port.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1216
Message
Probable Cause
Indicates that the number of AL_PA CRC errors has changed. This indicates that errors have been detected
in the FC frame. Invalid CRC messages occur when the number of CRC errors in Fibre Channel frames for
specific source ID (S_ID) and destination ID (D_ID) pairs change. These messages might also be caused by
<timestamp>, [FW-1194], <sequence-number>,, WARNING, <system-name>,
<Port Name>, <Label>, is above high boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1195], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, is between high and low boundaries(High=<High
value>, Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1216], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.