DCFM Enterprise User Manual (53-1001775-01, June 2010)

570 DCFM Enterprise User Manual
53-1001775-01
Encryption Targets dialog box
20
A confirmation dialog box describing consequences and actions required to recover launches.
4. Click YES to zeroize the encryption engine.
Encryption Targets dialog box
The Encryption Targets dialog box enables you to send outbound data that you want to store as
ciphertext to an encryption device. The encryption target acts as a virtual target when receiving
data from a host, and as a virtual initiator when writing the encrypted data to storage.
To access the Encryption Targets dialog box, complete the following steps.
1. Select Configure > Encryption from the menu bar.
The Encryption Center dialog box displays, showing the status of all encryption-related
hardware and functions.
2. Select the Group >Targets, Switch > Targets, or Engine > Targets, from the tool bar menu, or
right-click on the group, switch, or encryption engine in the Encryption Devices table, and
select Targets.
The Encryption Targets dialog box (Figure 256) displays the targets currently being encrypted
by the selected group, switch, or encryption engine. If a group is selected, all configured targets
in the group are displayed. If a switch is selected, all configured targets for the switch are
displayed.
The Encryption Targets dialog box enables you to launch a variety of wizards and other related
dialog boxes, which are defined in Table 24.