Installation Guide for the b3000 v1 - Technical White Paper

[Enter your Document Title]
[Document Restriction Notice]
•
A
llows access to network resources.
• Is published to network clients under a unique server name.
• Is associated with a network name and an IP address.
Creating a Virtual Server with the WEBUI
Create a new Cluster Group
• Open the WEBUI and select the Cluster Management Link on the left hand side.
• Click on the Resource Groups link and select NEW
• Enter a name, description and set the preferred nodes. Select OK to create the
new Group
Create an IP Address resource
• Select the Resources link under Cluster Management.
• Select NEW, select NEXT.
• Specify the resource name, description, type and the cluster group it needs to
reside in. The type will be IP Address. The group should be the cluster group
created in the previous steps. Select NEXT.
• Specify the possible nodes. (should be both nodes) Select NEXT.
• Specify the dependencies. IP addresses do not have any dependencies. Select
NEXT.
• Enter the IP Address, Subnet and preferred network. Select NEXT.
• Confirm that all parameters are correct and select FINISH to create the resource.
Create a Network Name Resource
• Select the Resources link under Cluster Management.
• Select NEW, select NEXT.
• Specify the resource name, description, type and the cluster group it needs to
reside in. The type will be Network Name. The group should be the cluster
group created in the previous steps. Select NEXT.
• Specify the possible nodes. (should be both nodes) Select NEXT.
• Specify the dependencies. Network Names must be dependent on an IP address
resource.
• Enter the name and select NEXT.
• Verify the parameters and select FINISH to create the resource.
Creating a Virtual Server with Terminal Services
Open Cluster administrator. Cluster administrator can be opened by selecting Start->Run-
>cluadmin
• Select FILE->NEW->GROUP
• Type the name for the new group and enter a description if desired. Select
NEXT to continue.
• Select the preferred owner. This is generally one of the two servers listed. In an
active-active cluster configuration you would set half of the groups to be
preferred by one node and the other groups to be preferred by the other node.
• Select Finish creating the new group.
• Select FILE->NEW->RESOURCE
• This will be an IP Address resource, type a name for the resource. In the
resource type window select IP ADDRESS. In the Group window select the name
of the group previously created. Select NEXT to continue.
• Select the possible owners and select NEXT to continue. Usually both nodes are
26