NAS b3000 v2 - Quick Start Guide (326190-002)

Configuration Setup
43NAS b3000 v2 Quick Start Guide
Figure 9: Rapid Startup wizard screen
12. Using the information from Table 2 in Chapter 2, fill in the screens that
follow. Verify that your information is correct when the configuration review
screen is displayed as shown in Figure 10. Online help is available for all
pages by clicking the “?” in the right side of the Web UI.
13. Click the Finish icon to complete Rapid Startup. If a reboot is required, Rapid
Startup will present a message that a reboot is occurring.
14. The browser will refresh to the status page of the NAS device. The refresh
may take several minutes if the device was restarted. Click on the HP utilities
tab and select the SAN Connection Tool. Do not connect storage until
instructed to do so by the tool.
15. For cluster deployments only, repeat steps 7-14 with the second node. After
the second node is configured, follow the online Cluster Install Guide found in
the Cluster tab of the Web UI. Additional information can also be found in
Chapter 4 of this document as well as the cluster section of the administration
guide.
16. Exit the RapidLaunch utility and remove the RapidLaunch CD from the
DVD-ROM drive and store it in a secure location.