NAS b3000 v2 - Quick Start Guide (326190-002)

Configuration Setup
40 NAS b3000 v2 Quick Start Guide
4. Power on the Windows-based PC and wait until the operating system has
completely loaded.
5. Insert the RapidLaunch CD into the DVD-ROM drive of the Windows-based
PC.
6. The RapidLaunch CD should automatically run. If the program does not start
up automatically, the program may be run manually. Click Start, and then
select Run on the Windows taskbar, and then type the following:
{CD ROM drive}:\setup.exe
Wait for the interface to start up.
7. Go to the NAS device and power it on. It will be several minutes before the
NAS device is accessible on the network.
8. Return to the Windows-based PC. Select StorageWorks NAS from the Show
drop down list to have RapidLaunch list all NAS devices on the network, as
shown in Figure 7.
Note: Connect a loopback cable to any of the NAS b3000 v2 Ethernet ports that are
not configured for use.