HP Storage Management Utility user guide (383075-002, July 2008)

1. Select Storage System > Clear Conﬁguration.

2. Select the conﬁguration components to clear.

NOTE:

• Select all—Clears all iSCSI, storage, and management conﬁguration settings.

•iSCSIConﬁguration—Clears iSCSI conﬁguration settings only.

• Management Conﬁguration—Clears management conﬁguration settings only.

•StorageConﬁguration—Clears storage conﬁguration settings only.

• When management settings are cleared, any changes to the management port IP

address are erased and a new IP address is assigned to the management port. To obtain

the new IP address, press the arrow buttons on the front of the array controller and scroll

through the LCD messages until the following message is displayed: 603 Port MA0

IP <address>. Record the new IP address, so that you can again access the SMU.

3. A warning message is displayed. Review the selected options and respond appropriately.

Deleting a component (Delete)

If necessary, the following components can be deleted:

• Arrays

• Logical drives

• Targets

• Mapped logical drives

• Initiators

• Data port IP addresses

• IP address portals

• Routes

• Target portal groups

To delete a component, select the component from the list, and then select Delete from the task list.

HP Storage Management Utility user guide