Compaq StorageWorks HSG60 ACS Solution V8.6 for SGI IRIX Installation and Configuration Guide

Preparing the Host System 3–7
NOTE: The following entries are for Fabric only.
For Irix V6.5.9 or earlier, use:
#
fx – x – d /dev/rdsk/50001fe1000007e0/lun0vol/c5p50001fe1000007e1
For Irix V6.5.10 or earlier, use:
#
fx – x – d /dev/rdsk/50001fe1000007e0/lun0vol/c5p1
fx version 6.5, Dec 31, 2000
...opening c5p50001fe1000007e1
...drive selftest...OK
NOTE: The following entries are for both Arbitrated Loop and Fabric.
Scsi drive type == DEC HSG60 V86
fx: Warning: no sgilabel on disk
fx: Warning: can't read sgilabel on disk
creating new sgilabel
----- please choose one (? for help,. to quit this menu)-----
[exi]t [d]ebug/ [l]abel/ [a]uto
[b]adblock/ [exe]rcise/ [r]epartition/ [f]ormat
fx>
label
----- please choose one (? for help, .. to quit this menu)-----
[sh]ow/ [sy]nc [se]t/ [c]reate/
fx/label>
set
----- please choose one (? for help, .. to quit this menu)-----
[para]meters [part]itions [s]giinfo
[g]eometry [m]anufacturer_params [b]ootinfo
fx/label/set>
parameters
fx/label/set/parameters: Error correction = (enabled)
fx/label/set/parameters: Data transfer on error = (enabled)
fx/label/set/parameters: Report recovered errors = (enabled)
disabled
fx/label/set/parameters: Delay for error recovery = (enabled)
fx/label/set/parameters: Err retry count = (4)
fx/label/set/parameters: Transfer of bad data blocks = (enabled)
fx/label/set/parameters: Auto bad block reallocation (write) = (enabled)
fx/label/set/parameters: Auto bad block reallocation (read) = (enabled)
fx/label/set/parameters: Read ahead caching = (enabled)
fx/label/set/parameters: Write buffering = (disabled)
fx/label/set/parameters: Drive disable prefetch = (0)
fx/label/set/parameters: Drive minimum prefetch = (0)
fx/label/set/parameters: Drive maximum prefetch = (0)
fx/label/set/parameters: Drive prefetch ceiling = (0)
fx/label/set/parameters: Enable CTQ = (disabled)
enabled
fx/label/set/parameters: CTQ depth = (2) 3