Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Linux X86 and Alpha Installation and Configuration Guide
Configuration Procedures 5–5
Figure 5–2. Single controller cabling
Configuring a Single Controller Using CLI
To configure a single controller using CLI involves the following processes:
■ Verify the Node ID and Check for Any Previous Connections.
■ Configure Controller Settings.
■ Restart the Controllers.
■ Set Time and Verify All Commands.
■ Plug in the FC Cable and Verify Connections.
■ Repeat Procedure for Each Host Adapter Connections
■ Verify Installation
Verify the Node ID and Check for Any Previous
Connections
1. Enter a SHOW THIS command to verify the node ID:
SHOW THIS
1 Controller
2 Host port 1
3 Host port 2
4 Cable from the switch to the host Fibre Channel adapter
5 FC switch
CXO6881B
1
5
5
3
2
4
4