Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–5
2. Remove previous versions of the Agent from your computer.
3. Read the release notes.
CAUTION: Do not install the Agent by using Dataless Management Services (DMS) or
Remote Installation Services (RIS) sever installations.
Installing and Configuring the Agent
The following instructions assume that you have a directory /mnt to which you can mount
the CD-ROM. If you do not, you must create a mount point and replace /mnt in the
following sequence with the mount point you created. It also assumes your CD-ROM
device is /dev/rz4c. If not, replace /dev/rz4c with the actual CD-ROM device.
IMPORTANT: Before you install the Agent, complete the steps in “Before You Install the Agent.”
1. Obtain the following information:
❏ Names of systems you want the Agent to contact
❏ Names of subsystems connected to the host
❏ Email addresses for the Agent to send status updates
2. Insert the CD-ROM into a computer.
3. Enter one of the following commands at the command prompt:
❏ For V4.0x enter:
# mount -r-t cdfs -o rrip /dev/rz6c /mnt
(Substituting rz6c if necessary for your CD-ROM)
❏ For V5.1x enter:
# mount -r-t cdfs /dev/disk/cdrom0c /mnt
(Substituting cdrom0c if necessary for your CD-ROM)
4. Change directories on the CD-ROM by entering:
# cd /mnt/agent
CAUTION: The version of Compaq Tru64 UNIX that you are using, either V4.0x or
V5.1x will determine which Device Special File Name format you will need to enter.