HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

SAN Director installation guide 137
Insert the B-Series MP Router blade into the 4/256 SAN Director
To install the B-Series MP Router blade:
1. Select an empty slot in the 4/256 SAN Director.
2. Make sure the latches on the B-Series MP Router blade are unscrewed and open.
3. Slide the B-Series MP Router blade into the open slot.
4. Close and screw the latches and power on the blade using the power switch at the top of the
blade. The B-Series MP Router blade begins POST. After the POST is complete, the firmware
version on the blade will autolevel with the firmware version on the active CP.
NOTE: The B-Series MP Router blade must operate with Fabric OS 5.1.x or higher.
Verify that the blade power and blade status LEDs are green after the blade has completed booting.
Figure 38 B-Series MP Router blade components
15
14
13
12
56-0000590-01 Rev A
!
7
6
5
4
3
2
1
0
GE1
GE0
15
14
13
12
11
10
9
8
56-0000590-01 Rev A
!
FR4
18i
3
2
1
0
GE1
GE0
FR4
18i
scale:
5/16" = 1"
scale:
5/16" = 1"
scale:
15/32" = 1"
scale:
15/32" = 1"
1
2
3
4
5
6
7
8
9
10
11
12
13
25198a