HP StorageWorks Fabric OS 5.2.x administrator guide (5697-0014, November 2009)

166 Installing and maintaining firmware
For more information on any of the commands in the Recommended Action section, see the Fabric OS
Command Reference.
NOTE: Some of the messages include error codes (as shown in the example below). These error codes
are for internal use only and you can disregard them.
Example: Port configuration with EX ports enabled along with trunking for port(s) 63, use the
portcfgexport, portcfgvexport, and/or portcfgtrunkport commands to remedy this. Verify blade is
ENABLED. (error 3)
Pre-installation messages
The messages in this section are displayed if an exception case is encountered during firmware download
from Fabric OS 5.2.x. The example below shows feature-related messages that you might see if you were
downgrading from v5.2.x to v5.1.x:
This example shows hardware-related messages for the same downgrade example:
Message
AP Blade type 24 is inserted. Please use slotshow to find out which slot it is in and remove it .
Probable Cause and Recommended Action
The firmware download operation was attempting to download Fabric OS 5.0.0 with one or more B-Series
MP Router port blades (blade ID 24) in the system. B-Series MP Router port blades are not supported on
firmware 5.0.0 or lower, so the firmware download operation is aborted.
Use the slotShow command to display which slot the B-Series MP Router port blade is in, and physically
remove the blade(s) from the chassis Retry the firmware download operation.
The following items need to be addressed before downloading the specified firmware:
Port mirror connections detected. Please use portmirror --delete to remove these
mirror connections.
AD feature is in use. Please clear it using the ad --clear command.
Port configuration with EX ports enabled along with trunking for port(s) 58, use the
portcfgexport, portcfgvexport, and/or portcfgtrunkport commands to disable the port
configuration. Verify that the blade is ENABLED. (error 3)
switch:admin> firmwaredownload
Server Name or IP Address: 10.1.2.3
FTP User Name: JaneDoe
File Name: /pub/v5.1.0
FTP Password: xxxx
Verifying the input parameters ...
Checking system settings for firmwaredownload...
The following items need to be addressed before downloading the specified firmware:
AP BLADE type 31 is inserted. Please use slotshow to find out which slot it is in and
remove it.
SW BLADE type 36 is inserted. Please use slotshow to find out which slot it is in and
remove it.
Firmwaredownload command failed.
switch:admin>