Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 179
53-1002149-01
EM-1035
25
Probable Cause Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified
reason.
Recommended
Action
Try reseating the FRU.
Run the systemVerification command to verify that the switch does not have hardware problems. To
run this command root access is required. Refer to the Fabric OS Command Reference for more
information on this command.
If the message persists, replace the FRU.
Severity ERROR
EM-1035
Message <timestamp>, [EM-1035], <sequence-number>,, ERROR, <system-name>, 2 circuit
paired Power Supplies are faulty, please check the <Switch side> AC main
switch/circuit to see if it has power.
Probable Cause Suggests that since both power supplies associated with one of the two main circuits are present
but faulty, maybe the circuit's switch has been turned off, or the AC power source has been
interrupted for that circuit.
The Switch side value is either "left" or "right" designating which circuit switch, facing the cable side
of the chassis. The Switch side value indicates:
• left: controls the odd numbered power supply units.
• right: controls the even numbered power supply units.
Recommended
Action
Check that the identified AC circuit switch is turned on, that the power cord is properly attached
and undamaged, and that the power source is operating properly.
Severity ERROR
EM-1036
Message <timestamp>, [EM-1036], <sequence-number>,, WARNING, <system-name>, <FRU Id> is
not accessible.
Probable Cause Indicates that the specified field-replaceable unit (FRU) does not seem to be present on the switch.
If the FRU is a world wide name (WWN) card, then default WWN and IP addresses are used for the
switch.
Recommended
Action
Reseat the FRU card.
If the message persists, reboot or power cycle the switch.
Run the systemVerification command to verify that the switch does not have hardware problems. To
run this command root access is required. Refer to the Fabric OS Command Reference for more
information on this command.
If the message persists, replace the FRU.
Severity WARNING