HP StorageWorks SAN Director Installation Guide (A7393-90009, May 2007)

Installing FRUs108
Installing a WWN card
Use these steps to install a new WWN card. See Figure 30 and Table 33.
1. Unpack the new WWN card and save the packaging for returning the faulty WWN card.
2. Install the WWN card:
• To install a WWN card that has handles: Hold the card by the handles and orient with the
LEDs at the top (see Figure 30 on page 107); then, align the connector on the card with the
connector on the chassis (the connectors are keyed to ensure correct installation) and use the
push pad to press the card onto the connector gently, until it is fully seated.
• To install a WWN card that does not have handles: Hold the card by the edges, press the
card onto the connector gently, until it is fully seated. Use the Phillips screwdriver to screw the
WWN card into the chassis with the two attaching screws.
The WWN card retains slight freedom of movement after installation.
CAUTION: Do not force the installation; if the card does not install easily, make sure it is correctly
oriented.
3Bezel
4Handle
5 WWN card with push pad
6WWN connector
7Push pad
8 Captive screw (two per bezel)
Table 33 WWN card components
Item Description