HP StorageWorks Fabric OS 6.x administrator guide (5697-7344, March 2008)

466 Configuring and monitoring FCIP extension services
Disabling FC fastwrite on a blade or switch
Disable FC fastwrite using the fastwritecfg command. Disabling FC fastwrite with this command
disrupts data traffic. For the FR4-18i blade, the command powers the blade off and back on. In the case of
the 400 Multi-protocol Router, the switch is rebooted. The process takes up to five minutes.
#fastwritecfg —disable slot#
Where slot# is the slot in which the FR4-18i blade is installed. A slot number is not required for the
400 Multi-protocol Router.
Example:
Disabling FC fastwrite on a port
To disable FC fastwrite on a port, enter the following command.
#portcfg fastwrite slot#/port_id —disable
Where slot# is the slot in which the FR4-18i is installed, and port_id is the port number. A slot number is
not required for the 400 Multi-protocol Router.
SJ3_6A1_12000_0:root> fastwritecfg --disable 7
!!!! WARNING !!!!
Disabling FC Fastwrite will require powering off and back on the
and it may take upto 5 minutes. For non bladed system, the switch
will be rebooted. Data traffic will be disrupted.
Continue (Y,y,N,n): [ n] y
Slot 7 is being powered off