HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

152 Error messages
FABS-1006
Message
Probable Cause
Indicates that there is no device in the slot with the specified object type ID in the system module record.
This could indicate that a serious Fabric OS data problem on the switch. The possible values for function
name and description of problem are:
• setSoftState: bad object
• setSoftState: invalid type or unit
• media_sync: Media oid mapping failed
• fabsys_media_i2c_op: Media oid mapping failed
• fabsys_media_i2c_op: obj is not media type
• media_class_hndlr: failed sending media state to blade driver
Recommended Action
If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the fabric
failed, fail over or reboot the switch.
If the message persists, run the firmwareDownload command to update the firmware.
Severity
WARNING
FABS-1007
Message
Probable Cause
Indicates that the Fabric OS has detected an invalid value in an object's status field. This is usually an
internal Fabric OS problem or file corruption.
Recommended Action
Reboot or power cycle the switch.
If the message persists, run the firmwareDownload command to update the firmware.
Severity
WARNING
<timestamp>, [FABS-1006], <sequence-number>,, WARNING,
<system-name>, <Function name and description of problem>: object
<object type id> unit <slot>
<timestamp>, [FABS-1007], <sequence-number>,, WARNING,
<system-name>, <Function name>: Media state is invalid -
status=<Status value>