Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

38 Fabric OS Message Reference
53-1000437-01
AUTH-1028
3
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1028
Message <timestamp>, [AUTH-1028], <sequence-number>,, ERROR, <system-name>, Failed to
allocate <data type> for <operation phase>: port <port number>.
Probable Cause Indicates that the authentication process failed because the system is low on memory.
Data type is the payload or structure that failed to get memory. Operation phase specifies which
operation of a particular authentication phase failed.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1029
Message <timestamp>, [AUTH-1029], <sequence-number>,, ERROR, <system-name>, Failed to get
<data type> for <message phase> message: port <port number>, retval <error code>.
Probable Cause Indicates that the authentication process failed to get a particular authentication value at certain
phase.
Data type is the payload or structure that failed to get memory.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1030
Message <timestamp>, [AUTH-1030], <sequence-number>,, ERROR, <system-name>, Invalid
message code for <message phase> message: port <port number>.