Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 35
53-1000437-01
AUTH-1017
3
Probable Cause This may relate to an internal failure.
Recommended
Action
Copy the message, collect switch information using the supportShow command, and contact your
switch service provider.
Severity ERROR
AUTH-1017
Message <timestamp>, [AUTH-1017], <sequence-number>,, ERROR, <system-name>, Invalid value
to start authentication request: port <port number>, operation code <operation
code>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1018
Message <timestamp>, [AUTH-1018], <sequence-number>,, ERROR, <system-name>, Invalid value
to check protocol type: port
<port number>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1020
Message <timestamp>, [AUTH-1020], <sequence-number>,, INFO, <system-name>, Failed to
create timer for authentication: port
<port number>.
Probable Cause Indicates that an authentication message's timer was not created.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.