Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

79-8 Fabric OS Message Reference
Publication Number: 53-1000242-01
SULB-1009
79
0x18 - Error in getting lock device for firmwaredownload. This error can occur because another
firmwareDownload is already in progress. Run firmwareDownloadStatus command to verify that is
the case. Wait until the current session to finish before proceeding.
0x23 - firmwareDownload timed out. This error can occur because firmwareDownload has not been
completed within the predefined timeout period. It is mostly caused by network issues. If the problem
persists, contact your system administrator.
0x24 - out of disk space. This error can occur because some coredump files have not been removed
from the filesystem and thus fill up the disk space. Remove these coredump files using the saveCore
command before proceeding.
0x29 - The pre-install script failed. This error can be caused by an unsupported blade type in the chassis.
Remove or power off the unsupported blades before proceeding. This can also be caused by an invalid
chassisConfig option setting. In that case, reset the chassisConfig option before retrying
firmwareDownload.
0x2e - Invalid RPM package. Please reload firmware packages on the file server. This error can be
caused by an inconsistent firmware image loaded on the file server. It can also be caused by temporary
networking issues. Retry the firmwareDownload. If the problem persists, contact your system
administrator.
Table 79-3 lists the firmwareDownload state names and state values. They indicate where in the
firmwareDownload process the error occurred.
Table 79-3 Upgrade State and Code Value
Upgrade State Code
SUS_PEER_CHECK_SANITY 0x21
SUS_PEER_FWDL_BEGIN 0x22
SUS_SBY_FWDL_BEGIN 0x23
SUS_PEER_REBOOT 0x24
SUS_SBY_REBOOT 0x25
SUS_SBY_FABOS_OK 0x26
SUS_PEER_FS_CHECK 0x27
SUS_SELF_FAILOVER 0x28
SUS_SBY_FWDL1_BEGIN 0x29
SUS_SELF_FWDL_BEGIN 0x2a
SUS_SELF_COMMIT 0x2b
SUS_SBY_FWC_BEGIN 0x2c
SUS_SBY_COMMIT 0x2d
SUS_SBY_FS_CHECK 0x2e
SUS_ACT_FWC_BEGIN 0x2f
SUS_PEER_RESTORE_BEGIN 0x30
SUS_SBY_RESTORE_BEGIN 0x31