Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 73-9
Publication Number: 53-1000242-01
ZONE-1029
73
Probable
Cause
Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the zone
database size depends on the lowest level switch in the fabric. Older switches have less memory and
force a smaller zone database for the entire fabric.
Recommended
Action
Edit the zone database to keep it within the allowable limit for the specific switches in your fabric. Refer
to the Fabric OS Administrator’s Guide for information on the zone database sizes supported for each
switch.
Severity WAR NIN G
ZONE-1029
Message
Probable
Cause
Indicates that the zone configuration restored from the flash was faulty.
Recommended
Action
This error will save the faulty zone configuration in the zoned core file directory. Run the saveCore
command to save the file.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
ZONE-1030
Message
Probable
Cause
Indicates that the current zone database could not be converted to reflect the PID format change. Most
likely this is caused by the size of the zone database.
Recommended
Action
Change the PID format back to its original format. Reduce the size of the zone database. Then you can
change the PID format to the requested format.
Severity WAR NIN G
<timestamp>, [ZONE-1029], <sequence-number>,, WARNING, <system-
name>, Restoring zone cfg from flash failed - bad config saved to
<config file name> [<return code>]
<timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-
name>, Converting the zone db for PID format change failed