Brocade Access Gateway Admin Guide v6.1.0 (53-1000605-02, June 2008)

Access Gateway Administrator’s Guide 21
53-1000605-02
Access Gateway policies
2
Renaming a port group
1. Connect to the switch and log in as admin.
2. Enter the command ag --pgrename with the <PG_ID> <newname> operands, for example, to
rename port group with pgid 2 to "MyEvenFabric":
switch:admin> ag --pgrename 2 MyEvenFabric
Port Group 2 has been renamed as MyEvenFabric successfully
3. Enter the command ag --pgshow to verify the port group has been renamed.
switch:admin> ag --pgshow
PG_ID N_Ports PG_Name
--------------------------------------
0 None pg0
2 0;2 MyEvenFabric
3 1;3 FirstFabric
Disabling the Port Group policy
1. Connect to the switch and log in as admin.
2. Enter the command ag --policydisable with the pg operand.
switch:admin> ag --policydisable pg
3. Enter the command ag --pgshow to verify the Port Group policy is disabled.
switch:admin> ag --policyshow
AG Policy Policy Name State
----------------------------------------------------------
Port Grouping pg Disabled
Auto Port Configuration auto Disabled
Advance Device Security ADS Disabled
----------------------------------------------------------
Access Gateway policy enforcement matrix
The following table shows which combinations of policies can co-exist with each other.
TABLE 3 Policy enforcement matrix
Policies Auto Port Configuration Port Grouping N_Port Trunking ADS Policy
Auto Port Configuration
NA Mutually exclusive Can co-exist Can co-exist
N_Port Grouping
Mutually exclusive N/A Can co-exist Can co-exist
N_Port Trunking
Can co-exist Can coexist N/A Can co-exist
ADS Policy
Can co-exist Can co-exist Can co-exist N/A