HP StorageWorks 3800ux/7100ux Optical Jukebox Conversion Guide (AA969-96003, May 2004)

Configuration
35HP StorageWorks 3800ux/7100ux Optical Jukebox Setup Guide
Connection to HP-UX (11.x)
The following procedures are for configuring an HP-UX operating system to use
native drivers with UDO jukeboxes.
Obtaining HP-UX patches
Your HP-UX system may require software patches to ensure that the standalone
UDO drive will install and operate correctly with your system. HP-UX versions
11.0, 11.11 and 11.23 require patches. To view the most up-to-date list of patch
requirements, visit
http://www.hp.com/go/udo . To download required patches,
go to
http://www.hp.com/go/ support or refer to your HP-UX documentation for
patch locations.
Note: HP-UX versions 11.x provide limited native support for jukeboxes, including file
system support for rewritable media and a SCSI driver (schgr) for the jukebox
robotics.
Note: When using a third party application, HP recommends you consult with the
application vendor for configuration requirements and recommendations.
Installing the schgr driver
The schgr driver is an HP-UX native SCSI driver that allows commands to be
sent to a media changer.
1. Log on to the system as root.
2. Initialize SAM by typing sam at the command line.
Note: If you are not familiar with using SAM, consult your HP-UX documentation.
3. Select the following items from the menus that are displayed:
■ Kernel Configuration
■ Drivers
4. Scroll down to the entry “schgr”.