2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

351000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Installing the drives

Follow the procedures in Installing 2 UDO drives. If the customer is building a mixed-media

jukebox, also follow the procedures in Retrofitting and reinstalling MO drives after installing

the UDO drives.

Installing 2 UDO drives

To install 2 UDO drives:

1. Affix the new drive identification and cabling label on the jukebox frame above the

interposer board, covering the existing label (see Figure 19).

Figure 19: Drive identification and cabling label

2. For each UDO drive you assemble, take an MO drive out of its drive module. You will

re-use its drive module and its power cable for the UDO drive.

3. Assemble the UDO drives into drive modules. For each drive:

a. Insert the drive into the drive module from the previous step.

b. Connect the SCSI cables and the power cable to the drive and thread them through the

holes in the module.

c. Secure the drive to the module using four screws, supplied.

d. Install and secure the cable access panel on the drive module.

Note: If there is a configuration module present, the unit must have either 4 drives, or 2 drives and

76 slots.

1 Location of label 2 Location of interposer board